Overview of Using Lookup Tables to Assign Data to Dynamic Blocks

Up a level to ..

Overview of Using Lookup Tables to Assign Data to Dynamic Blocks

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Actions and Parameters to Dynamic Blocks > Use Lookup Tables to Assign Data to Dynamic Blocks > 

Overview of Using Lookup Tables to Assign Data to Dynamic Blocks

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

To create a lookup table for a dynamic block

1. Click Insert tab Block panel Block Editor. At the Command prompt, enter bedit.
2. In the Block Editor, add one or more lookup parameters to a dynamic block definition by following the steps in To add a lookup parameter to a dynamic block definition.
3. In the Block Editor, add a lookup action to a dynamic block definition by following the steps in To add a lookup action to a dynamic block definition.

   The Property Lookup Table dialog box is displayed.

4. Use any of the following procedures to set up a lookup table for the dynamic block:
   • To add input properties to a lookup table
   • To add lookup properties to a lookup table
   • To enable reverse lookup
5. Click Block Editor tab Open/Save panel Save Block. At the Command prompt, enter bsave.
6. (Optional) If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Standard 

 Command entry: BPARAMETER