Add a Stretch Action

Up a level to ..

Add a Stretch Action

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Actions and Parameters to Dynamic Blocks > Add Actions to Dynamic Blocks > 

Add a Stretch Action

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

To add a stretch action to a block definition

1. Click Insert tab Block panel Block Editor. At the Command prompt, enter bedit.
2. Click Block Editor tab Action Parameters panel Stretch.In the Block Editor, in the Block Authoring Palettes window, Actions tab, click the Stretch Action tool.
3. In the Block Editor drawing area, select one of the following parameters to associate with the action:
   • Point
   • Linear
   • Polar
   • XY
   NoteIf you associated the stretch action with a point parameter, then skip the next step.
4. Select a parameter point to associate with the action.
5. Specify the first corner of the stretch frame.
6. Specify the opposite corner of the stretch frame.
7. Select the objects for the selection set. Press Enter.
8. (Optional) Follow the Command prompts to specify a distance multiplier and angle offset.
9. Specify the location of the action.
10. Click Block Editor tab Open/Save panel Save Block. At the Command prompt, enter bsave.
11. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Standard 

 Command entry: BACTION