ALM-11788 GPS satellite signal lost alarm

Description

When GPS receiver can not receive the GPS satellite signal, the alarm occurs.

Attribute

Alarm ID Alarm Severity Alarm Type
11788 Warning Fault

Parameters

ID Name Meaning
1 Site No.

Number of the site where the faulty board or module is located

Value range: 0-2047

2 Board Type

Number of the type which the faulty board belongs to.

99:DGPS

3 Board No.

Number of the fault board

0-35:DGPS

4 PassNo

Number of the passage where the faulty board is located.

5 SubLink No.

Alarm sub-category number

255:None

6 Cell Index

Index of the cell where the board or module is located

0-2047: Cell index of the faulty cell in the data configuration

65535: None

7 Site Type

Type of the site where the faulty board is located.

12:BTS3012;

15:BTS3012AE;

16:BTS3012 II;

8 RackNo

Number of the rack where the faulty board is located.

9 BoxNo

Number of the subrack where the faulty board is located.

10 SlotNo

Number of the slot where the faulty board is located.

11 Site Name

Site Name

12 Alarm Attribute

Alarm Character

0:Normal

1:Transient Count

Impact on the System

The GPS receiver cannot lock the satellite.

System Actions

None.

Possible Causes

The GPS signals might temporarily get lost due to external reasons, such as shielding obstacles or adverse weather conditions.

Procedure

  1. Check whether the GPS antenna failure alarm is reported on the LMT.

    Y=> Handle the alarm according to handling suggestions in GPS antenna failure alarm.

    N=> Go to step 2.

  2. Check the GPS antenna.
    1. Check whether the GPS antenna is shielded by obstacles.

      Y=> Go to step b.

      N=> Go to step 3.

    2. Remove the obstacles, and then check whether the alarm is cleared.

      Y=> The alarm handing ends;

      N=> Go to step 3.

  3. Check the DGPS board.

    Reset the DGPS board, and then check whether the alarm is cleared.

    Y=> The alarm handing ends;

    N=> Go to step 4.

  4. Replace the DGPS board, and then check whether the alarm is cleared.

    Y=> The alarm handing ends;

    N=> Go to step 5.

  5. Replace the GPS board, and then check whether the alarm is cleared.

    Y=> The alarm handing ends;

    N=> Contact Huawei Customer Service Center.


Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.