ALM-2604 EAC Extended F6 Alarm

Description

This alarm is reported when extended I/O F6 is abnormal. To enable the users to obtain the required alarm information, the LMT provides "** extended I/O alarm "and " extended ** alarm." This facilitates the users to define alarms themselves.

Attribute

Alarm ID	Alarm Severity	Alarm Type
2604	Warning	Fault

Parameters

ID	Name	Meaning
1	Site No.	Number of the site where the faulty board or module is located Value range: 0-2047
2	Board Type	Number of the type which the faulty board belongs to. 129:TMU
3	Board No.	Number of the fault board 0:TMU 0 1:TMU 1
4	PassNo	Number of the passage where the faulty board is located.
5	SubLink No.	Alarm sub-category number 255:None
6	Cell Index	Index of the cell where the board or module is located 0-2047: Cell index of the faulty cell in the data configuration 65535: None
7	Site Type	Type of the site where the faulty board or module is located 3: BTS30 5: BTS312 10: BTS3012A 11: BTS3006A
8	RackNo	Number of the rack where the faulty board is located.
9	BoxNo	Number of the subrack where the faulty board is located.
10	SlotNo	Number of the slot where the faulty board is located.
11	Site Name	Site Name
12	Alarm Attribute	Alarm Character 0:Normal 1:Transient Count

Impact on the System

The corresponding equipment to the extended I/O F6 cannot be monitored.

System Actions

None.

Possible Causes

The extended I/O F6 is faulty.
The sensor is faulty or the connections are faulty.
The alarm shielding is not correctly set.

Procedure

You can check the extended I/O F6 of the alarm box as follows:

Adjust the level on the I/O port.

Check whether the I/O port can report the alarm normally.

Check whether the sensor and the connections are well connected.

Check whether the alarm shielding is correctly set.

If the connections of the extended boolean are not connected, set the interface to the no alarm state.