| ID | Name | Meaning |
|---|---|---|
| 1 | Site No. | Number of the site where the faulty board or module is located Value range: 0-2047 |
| 2 | Board Type | Number of the type which the faulty board belongs to. 129:MMU |
| 3 | Board No. | Number of the fault board 0:MMU |
| 4 | PassNo | Number of the passage where the faulty board is located. |
| 5 | SubLink No. | Alarm sub-category number 255:None |
| 6 | Cell Index | Index of the cell where the board or module is located 0-2047: Cell index of the faulty cell in the data configuration 65535: None |
| 7 | Site Type | Type of the site where the faulty board or module is located 7: BTS3001C-108/BTS3001C-116 8: BTS3001C-204 |
| 8 | RackNo | Number of the rack where the faulty board is located. |
| 9 | BoxNo | Number of the subrack where the faulty board is located. |
| 10 | SlotNo | Number of the slot where the faulty board is located. |
| 11 | Site Name | Site Name |
| 12 | Alarm Attribute | Alarm Character 0:Normal 1:Transient Count |
When this alarm occurs, the BTS3001C clock module cannot provide normal clock signals.
Load the updated MMU software and activate it. After that, check whether the alarm is cleared.
Y=>The alarm handling ends.
N=>Go to step 2.
Perform fourth-level reset.Load the updated BTS3001C MMU software again and activate it. After that, check whether the alarm is cleared.
Y=>The alarm handling ends.
N=>The possible cause is that the hardware in the BTS3001C is faulty. Please contact Huawei Customer Service Center.