ALM-4764 SW Not Activated Alarm

Description

This alarm is reported when the TRX board software is not activated.

Alarm ID	Alarm Severity	Alarm Type
4764	Warning	Fault

ID	Name	Meaning
1	Site No.	Number of the site where the faulty board or module is located Value range: 0-2047
2	Board Type	Number of the type which the faulty board belongs to. 64:DTMU/DOMU 87:GTMU
3	Board No.	Number of the fault board 0-7:DTMU/DOMU/GTMU
4	PassNo	Number of the passage where the faulty board is located.
5	SubLink No.	Alarm sub-category number 255:None
6	Cell Index	Index of the cell where the board or module is located 0-2047: Cell index of the faulty cell in the data configuration 65535: None
7	Site Type	Type of the site where the faulty board is located. 12:BTS3012; 13:BTS3006C; 14:BTS3002E; 15:BTS3012AE; 16:BTS3012 II; 17:DBS3900 GSM; 18:BTS3900 GSM; 19:BTS3900A GSM;
8	RackNo	Number of the rack where the faulty board is located.
9	BoxNo	Number of the subrack where the faulty board is located.
10	SlotNo	Number of the slot where the faulty board is located.
11	Site Name	Site Name
12	Alarm Attribute	Alarm Character 0:Normal 1:Transient Count

There is no impact on services but the features of new versions may be unusable.

None.

The downloaded software of the TRX board is not activated.

Activate the software. Check whether the software activation is successful.
Y => The software activation is successful. Go to procedure 4.

N => The software activation fails. Go to procedure 2.
Check whether the software version to be activated is correctly loaded to the OMU or GBAM on the BSC.
Y => The software version is correctly loaded. Go to procedure 4.

N => The software version is incorrectly loaded. Go to procedure 3.
According to the software configuration requirements, load the software to the OMU or GBAM on the BSC. Perform the software activation. Then, check whether the alarm is cleared.
Y => The alarm is cleared. No further action is required.

N => The alarm is not cleared. Go to procedure 4.
Check whether there is a board that is installed and powered on but not configured on the LMT.
Y => There is such a board. Go to procedure 5.

N => There is no such board. Contact Huawei Customer Service Center.
Power off the board. Alternatively, configure, activate, and then delete the board on the LMT. Check whether the alarm is cleared.
Y => The alarm is cleared. No further action is required.

N => The alarm is not cleared. Contact Huawei Customer Service Center.