| ID | Name | Meaning |
|---|---|---|
| 1 | Site No. | Number of the site where the faulty board or module is located Value range: 0-2047 |
| 2 | Board Type | Number of the type which the faulty board belongs to. 87:GTMU |
| 3 | Board No. | Number of the fault board 0-7:GTMU |
| 4 | PassNo | Number of the passage where the faulty board is located. |
| 5 | SubLink No. | Alarm sub-category number 0: SFP 0 port 1: SFP 1 port 2: SFP 2 port 3: SFP 3 port 4: SFP 4 prot 5: SFP 5 prot |
| 6 | Cell Index | Index of the cell where the board or module is located 0-2047: Cell index of the faulty cell in the data configuration 65535: None |
| 7 | Site Type | Type of the site where the faulty board is located. 17:DBS3900 GSM; 18:BTS3900 GSM; 19:BTS3900A GSM; |
| 8 | RackNo | Number of the rack where the faulty board is located. |
| 9 | BoxNo | Number of the subrack where the faulty board is located. |
| 10 | SlotNo | Number of the slot where the faulty board is located. |
| 11 | Site Name | Site Name |
| 12 | Alarm Attribute | Alarm Character 0:Normal 1:Transient Count |
When the alarm is generated, partial or all RRUs on the RRU chain/ring on the SFP port may not work properly.
Check whether the optical cables between the BBU and RRU are properly connected.
Y=> Go to step 2;
N=> Go to step 3;
Y=> The alarm handing ends;
N=> Go to step 3;
Self loop the CPRI on the BBU, and then check whether the alarm is cleared.
Y=> Replace the faulty DRRU. If the alarm persists, contact Huawei Customer Service Center;
N=> Replace the faulty GTMU. If the alarm persists, contact Huawei Customer Service Center.