ALM-5348 Cavity Board Type Mismatch

Description

This alarm is reported when either of the following situations occurs:The DFCU is configured in the BSC while actually the DFCB is installed in the BTS. The DFCB is configured in the BSC while actually the DFCU is installed in the BTS.

Attribute

Alarm ID	Alarm Severity	Alarm Type
5348	Warning	Fault

Parameters

ID	Name	Meaning
1	Site No.	Number of the site where the faulty board or module is located Value range: 0-2047
2	Board Type	Number of the type which the faulty board belongs to. 75:DFCU 76:DFCB
3	Board No.	Number of the fault board Value range:0-35
4	PassNo	Number of the passage where the faulty board is located.
5	SubLink No.	Alarm sub-category number 255: None
6	Cell Index	Index of the cell where the board or module is located 0-2047: Cell index of the faulty cell in the data configuration 65535: None
7	Site Type	Type of the site where the faulty board is located. 12:BTS3012; 15:BTS3012AE; 16:BTS3012 II;
8	RackNo	Number of the rack where the faulty board is located.
9	BoxNo	Number of the subrack where the faulty board is located.
10	SlotNo	Number of the slot where the faulty board is located.
11	Site Name	Site Name
12	Alarm Attribute	Alarm Character 0:Normal 1:Transient Count

Impact on the System

The system operates normally. But the TRX mutual-aid mechanism cannot be fully implemented.

System Actions

None.

Possible Causes

The DFCU is configured in the BSC while actually the DFCB is installed in the DFCB.
The DFCB is configured in the BSC while actually the DFCU is installed in the DFCB.

Procedure

Install the DFCU or DFCB based on the configuration from the BSC and check whether the alarm is cleared.
Y=> The alarm is cleared. The alarm handling is complete.

N=> The alarm persists. Please contact Huawei Customer Service Center.