ALM-9746 BBU Temprature Alarm

Description

The temperature of the BBU is higher than the upper threshold or lower than the lower threshold. 0:the temperature at the air inlet of the fan is higher than the upper threshold. 1:the temperature at the air inlet of the fan is lower than the lower threshold.

Attribute

Alarm ID Alarm Severity Alarm Type
9746 Major Fault

Parameters

ID Name Meaning
1 Site No.

Number of the site where the faulty board or module is located

Value range: 0-2047

2 Board Type

Number of the type which the faulty board belongs to.

89:UBFA

3 Board No.

Number of the fault board

0:UBFA

4 PassNo

Number of the passage where the faulty board is located.

5 SubLink No.

Alarm sub-category number

0: over the hith limit

1: low the low limit

6 Cell Index

Index of the cell where the board or module is located

0-2047: Cell index of the faulty cell in the data configuration

65535: None

7 Site Type

Type of the site where the faulty board is located.

18:BTS3900 GSM;

19:BTS3900A GSM;

8 RackNo

Number of the rack where the faulty board is located.

9 BoxNo

Number of the subrack where the faulty board is located.

10 SlotNo

Number of the slot where the faulty board is located.

11 Site Name

Site Name

12 Alarm Attribute

Alarm Character

0:Normal

1:Transient Count

Impact on the System

When the alarm is generated, the hardware might be damaged, thus affecting the services.

System Actions

None.

Possible Causes

  • The ambient temperature is too high or too low;
  • The temperature sensor is faulty;
  • The fan board is faulty.

Procedure

  1. Check whether the ambient temperature is higher than the upper temperature threshold.

    Y=> Adjust the temperature in the equipment room. Go to step 4;

    N=> Go to step 2.

  2. Check whether the fan fault alarm is reported on the LMT.

    Y=> Replace the faulty fan board. Go to step 4;

    N=> Go to step 3.

  3. Reset the fan board. Check whether the alarm is cleared.

    Y=> The alarm handing ends;

    N=> Replace the fan.

  4. Check whether the alarm is cleared.

    Y=> The alarm handing ends;

    N=> Contact Huawei Customer Service Center.


Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.