Connecting the LMT PC to the GBAM/GOMU

This provides an example of connecting the LMT PC to the GBAM/GOMU in a LAN to describe how the LMT PC is connected to the OM network of the BSC. You need to perform this operation only when the LMT is used for the first time.

Prerequisites

Procedure

1. Set the IP address of the LMT PC. For details, refer to Setting IP Address of LMT PC.
2. On the LMT PC, choose Start > Run. In the Run dialog box, type cmd, and then press Enter. The cmd.exe window is displayed.

   Table 1 Level standard of IP network

   Network level	Single-way time delay(ms)	Packet loss ratio	Jitter(ms)
   Good	≤40	≤0.1％	≤10
   Normal	≤100	≤1％	≤20
   Bad	≤400	≤5％	≤60

3. In the cmd.exe window, type ping external IP address of GBAM/GOMU.Table 1 shows the Level standard of IP network

   If the information similar to the following display is returned, you can infer that the LMT PC and the GBAM/GOMU can communicate normally. In this example, the IP address of the external network is 10.121.71.228.

   Pinging 10.121.71.228 with 32 bytes of data: Reply from 10.121.71.228: bytes=32 time=1ms TTL=253 Reply from 10.121.71.228: bytes=32 time=1ms TTL=253 Reply from 10.121.71.228: bytes=32 time=1ms TTL=253 Reply from 10.121.71.228: bytes=32 time=1ms TTL=253 Ping statistics for 110.121.71.228: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 1ms, Maximum = 1ms, Average = 1ms