The components on the GOMU panel are the LEDs and ports.
Figure 1 shows the GOMU panel.
Figure 1 GOMU panel
| (1) Screw | (2) Wrench | (3) Self-locking latch |
| (4) RUN LED | (5) ALM LED | (6) ACT LED |
| (7) Reset button | (8) SHUTDOWN button | (9) USB port |
| (10) ETH0 (Ethernet port) | (11) ETH1 (Ethernet port) | (12) ETH2 (Ethernet port) |
| (13) COM port | (14) VGA port | (15) HD LED |
| (16) OFFLINE LED | (17) Hard disk | (18) Screw for fixing the hard disk |
NOTE: The self-locking latch on the panel is used to fasten the ejector lever of the board.
The RESET button on the panel is used to reset the system.
To power off the GOMU, you should first unfold the upper and lower handles. After the OFFLINE LED is on, disconnect the power.
A COM port is on the panel for conenction to alarm box.
Do not perform any operation on the SHUTDOWN button on the GOMU panel; otherwise, the GOMU board may power off abnormally.