Maintaining DSP Resources

This describes how to maintain DSP resources. You can query the DSP status of the GDPUC, GDPUX, and GDPUP. You can also block and unblock DSPs.

Prerequisites

The LMT runs normally.
The communication between the LMT and the BSC is normal.
The GDPUC, GDPUX, or GDPUP is functional.

Context

You can block and unblock a DSP according to actual needs. When blocking a DSP, you can select Wait for user to release calls on DSP, Release all the calls on DSP immediately, or Release calls after n seconds.

Procedure

Through GUI
1. On the LMT, choose BSC Maintenance > Maintain User Resource > Maintain DSP Resource. A dialog box is displayed, as shown in Figure 1.
  Figure 1 Maintain DSP Resource dialog box
2. Set parameters in the Location area, and then click Query to query the DSP status of the specified board.
  - In the Query Result area, choose the DSP to be unblocked, and then click Unblock to unblock the DSP.
  - In the Query Result area, choose the DSP to be blocked, and then click Block to block the DSP.
3. Click Cancel.
Through MML
1. Run the BLK DSP command on the LMT to block the specified DSP.
2. Run the UBL DSP command on the LMT to unblock the specified DSP.