Querying the Resources of An MS

This describes how to query the usage of single-user resources in the CS and PS. The resources include the common information and mobile information about the MS and the information about BM subrack and TC subrack.

Prerequisites

Procedure

1. Choose BSC Maintenance > Maintenance User Resource > Query Single User Resource to query user resources.
2. Select Service Option, set the parameter in the Calling ID area, and then click Query. The query results are displayed, as shown in Figure 1.
   NOTE:

   • If you set the Calling ID to MSISDN (you are advised to trace the calling ID through the called ID):
     • If you trace the calling party, the MSISDN is the called ID, that is, the ID that the MS calls. For example, if the MS calls 12345, then the MSISDN is 12345.
     • If you trace the called party, the MSISDN is the calling ID. The MS must be enabled with caller ID display. If 54331 is displayed on the MS, specify the MSISDN with 54321; if 8654321 is displayed on the MS, specify the MSISDN with 8654321.
   • If you set the Calling ID to TMSI or IMSI, you must determine the reassignment strategy on the MSC side:
     • If TMSI is carried, you can query the MS through the TMSI.
     • If IMSI is carried, you can query the MS through the IMSI.
   • If you set the Calling ID to IMEI, you must determine whether the IMEI is available to the MSC.
   • If you set the Calling ID to TLLI, you must query the TLLI of the MS. You can run the DSP MSCONTEXT command on the Local Maintenance Terminal to query the TLLI of the MS.
   Figure 1 Querying single user resources