Querying Board Bar Code

This describes how to query the bar codes of BTS boards. You can query the bar codes of more than one BTS in one operation.

Prerequisites

The LMT runs normally.
The communication between the BSC and the BTS is normal.

Context

The bar code of a board indicates the manufacturing information about the board. When a single error occurs to several boards, query the bar codes to check whether the boards produced in a batch are faulty.

Procedure

Through GUI
1. Choose BTS Maintenance > Query Board Bar Code. A dialog box is displayed, as shown in Figure 1.
  Figure 1 Query Board Bar Code dialog box
2. Set Site Type, select the sites from the Candidate Sites box and add them to the Selected Sites, and click OK. The results are displayed, as shown in Figure 2.
  Figure 2 Querying the bar codes of BTS boards
3. Click Cancel to end the query.
Through MML
1. Run the DSP BTSBRDBARCOD command on the LMaT to query the bar codes of BTS boards.