Stop DSP TC Loop(STP DSPTCLOP)

Function

An OM command that stops the loopback test on the DSP channel.

Note

1. The DPU must work normally.

2. The subrack number and slot number to be entered are the numbers of the subrack and slot where the DPU is located.

3. The end channel number cannot be smaller than the start channel number.

Parameters

ID	Name	Description
SRN	Subrack No.	Meaning: subrack number Value range: 0-11 Explanation: This parameter specifies the number of the subrack in which the GDPUC or GDPUX is located. Default value: None
SN	Slot No.	Meaning: slot number Value range: 0-27 Explanation: This parameter specifies the number of the slot that holds the GDPUC or GDPUX. Default value: None
DSPN	DSP No.	Meaning: number of DSP Value range: 0-21 Explanation: This parameter specifies the number of the DSP. Default value: None
STRCHN	Start channel	Meaning: number of the start channel Value range: 0-69 Explanation: This parameter specifies the number of start channel. Default value: None
ENDCHN	End channel	Meaning: number of end channel Value range: 0-69 Explanation: The number of end channel must be greater than that of start channel. Default value: None

Example

Stop the loopback test on a DSP channel (Subrack No. = 1; Slot No. = 9; DSP No. = 0; Start channel = 0; End channel = 0):
STP DSPTCLOP: SRN=1, SN=9, DSPN=0, STRCHN=0, ENDCHN=0;

Output Description

None.