Parameter Name |
DL RX_LEV Upper Threshold |
|---|---|
Description |
The power control step is calculated based on the signal level. The signal level has an upper threshold and a lower threshold. Power control is not performed if the signal level is between the upper threshold and the lower threshold. Power control is performed only when the signal level exceeds the upper threshold or is below the lower threshold. The level values 0 through 63 map to -110 dBm to -47 dBm. |
GUI Value Range |
[0,63] |
Default Value |
45 |
Unit |
Levels |
Step |
- |
Modification Rules |
None |
Configuration Policy |
If this parameter is set to a too great value, the uplink level becomes high without power control. Thus, the battery life is reduced and the network interference is increased. If this parameter is set to a too small value, the downlink level becomes low, and call drop may easily occur. |
Recommended Value |
45 |
Parameter Relationship |
This parameter specifies the upper threshold of the downlink signal for power control. If the signal level exceeds this threshold, calculate a decreased value (= receive level - (DL RX_LEV Upper Threshold + DL RX_LEV Lower Threshold)/2). Compare the decreased value with MAX Down Adj.Value Qual.Zone 0, MAX Down Adj.Value Qual.Zone 1, MAX Down Adj.Value Qual.Zone 2, and MAX Down Adj. PC Value by Qual. Set the power adjustment step to the minimum value of the five. |
BSC Feature |
Power control |
Parameter Class |
Parameters About Radio Resources |
Caution |
For details, refer to DL RX_LEV Upper Threshold. |