Parameter Name |
AMR DL RX_LEV Upper Threshold |
|---|---|
Description |
The power control step is calculated based on the signal level. The signal level has an upper threshold and a lower threshold. Power control is not performed if the signal level is between the upper threshold and the lower threshold. Power control is performed only when the signal level exceeds the upper threshold or is below the lower threshold. The level values 0 through 63 map to -110 dBm to -47 dBm. |
GUI Value Range |
[0,63] |
Default Value |
33 |
Unit |
Levels |
Step |
- |
Modification Rules |
None |
Configuration Policy |
If this parameter is set to a too great value, the uplink level becomes high without power control. Thus, the battery life is reduced and the network interference is increased. If this parameter is set to a too small value, the downlink level becomes low, and call drop may easily occur. |
Recommended Value |
33 |
Parameter Relationship |
This parameter specifies the upper threshold of the downlink signal for power control. If the signal level is higher than this threshold, calculate a decreased value (= receive level - (DL RX_LEV Upper Threshold + DL RX_LEV Lower Threshold)/2). Compare this decreased value with the AMR MAX Down Aaj. Value Qual. Zone 0, AMR MAX Down Aaj. Value Qual. Zone 1, AMR MAX Down Aaj. Value Qual. Zone 2, and AMR MAX Down Adj. PC Value by Qual. Set the power adjustment step to the minimum value of the five. |
BSC Feature |
Power control, AMR |
Parameter Class |
Parameters About Radio Resources |
Caution |
For details, refer to AMR DL RX_LEV Upper Threshold. |