CR382:CELL_LOOP_START_FAIL
After the loopback start conditions are determined, the local switch call detection is performed, and a loopback request message is sent, the loopback start may fail because of various reasons. This measurement provides the number of loopback started failures.
Integer number or integer.
At the end of the granularity period, this counter is measured by using the following formula.
Number of Loopback Start Failures = [Number of Loopback Start Failures (No Loopback Policy Available)] + [Number of Loopback Start Failures (Speech Version Adjustment Failure)] + [Number of Loopback Start Failures (Invalid State)] + [Number of Loopback Start Failures (Failures on the BTS Side)] + [Number of Loopback Start Failure (Territorial Resource Request Failure)] + [Number of Loopback Start Failure (Timer Expired)] + [Number of Loopback Start Failures (Not Support by the BTS)] + [Number of Loopback Start Failures (Service)]+[Number of Loopback Start Failures (Other Causes)]