ACC1x: Network Setup (/N) Fails After Network Error

Last reviewed: May 14, 1997
Article ID: Q109817

The information in this article applies to:

Microsoft Access versions 1.0, 1.1

SYMPTOMS

If your network experiences a problem while you are running the Microsoft Access network installation (SETUP /N), you will receive an error message in Microsoft Access Setup. After you choose the Cancel button you will receive an error message stating that the system was previously set up, even though the installation was not completed successfully.

STATUS

Microsoft has confirmed this to be a problem in Microsoft Access versions 1.0 and 1.1. This problem no longer occurs in Microsoft Access version 2.0.

Keywords : kbsetup StpNet
Version : 1.0 1.1
Platform : WINDOWS
Hardware : X86
Issue type : kbbug
Resolution Type : kbfix

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 14, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.