Ethernet_802.3 Does Not Work with ODI/NDIS Support Driver

Last reviewed: September 9, 1996
Article ID: Q124798
The information in this article applies to:
  • Microsoft Windows NT Server version 3.5
  • Microsoft Network Client version 3.0 for MS-DOS

SYMPTOMS

When you use the ODI/NDIS Support driver and configure the NWLink IPX Compatible Transport protocol with the frame type of Ethernet_802.3 in Network Client version 3.0 for MS-DOS that is shipped with Windows NT Server version 3.5, the following message may appear when you attempt to log on to a Windows NT version 3.5 domain:

   You were logged on, but have not been validated by a server. Therefore,
   you may not have permission to use some network resources.

WORKAROUND

To work around this problem, either run the Network Client version 3.0 for MS-DOS Setup program or modify its PROTOCOL.INI file:

Run Network Client Setup Program

  1. Run the Setup program for Network Client version 3.0 for MS-DOS and select Change Network Configuration.

  2. For the Protocol, select NWLink IPX Compatible Transport, and for Options, select Change Settings.

  3. Select either one of the following for Frame Type:

          Ethernet _802.2
          Ethernet_II
          Ethernet _SNAP
    

  4. Exit Setup and restart the computer.

  5. On the Windows NT Server version 3.5, verify that you have the same frame type configured for the NWLink IPX/SPX Compatible Transport protocol in Network of Control Panel.

Modify PROTOCOL.INI

  1. Using a text editor such as EDIT.COM, open the PROTOCOL.INI file for the Network Client.

  2. In the [MS$NWLINK] section of PROTOCOL.INI, change the following:

          [MS$NWLINK]
          FRAME=Ethernet_802.3
    

    to

          [MS$NWLINK]
          FRAME=Ethernet_802.2 (or Ethernet_II or Ethernet_SNAP)
    

  3. Save and exit the text editor, and reboot the computer.

STATUS

Microsoft has confirmed this to be a problem in the Network Client version 3.0 for MS-DOS. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


Additional reference words: prodnt 3.10 3.50 3.11
KBCategory: kbnetwork kbinterop kbbug3.50
KBSubcategory: ntinterop



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 9, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.