FIX: "Record Is Not Locked" Exiting Numeric GET Field

Last reviewed: April 17, 1995
Article ID: Q88640

The information in this article applies to:

Microsoft FoxPro for MS-DOS, version 2.0

SYMPTOMS

In Microsoft FoxPro version 2.0 for MS-DOS, if a user exits a numeric GET field by pressing the ENTER key, a zero is placed in the field and the error message "Record is not Locked" is displayed.

CAUSE

This error would only happen if the value in the GET field was not the full width of the field and the code option READ NOLOCK was marked in the Screen Builder.

STATUS

Microsoft has confirmed this to be a problem in Microsoft FoxPro version 2.0 for MS-DOS. This problem was corrected in Microsoft FoxPro version 2.0 for MS-DOS dated March 25, 1992.

Additional reference words: FoxDos buglist2.00 fixlist2.00 2.00
KBCategory: kbprg kbfixlist kbbuglist
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.