How to Use the REPLACE Command in FoxPro 1.x

Last reviewed: April 17, 1995
Article ID: Q89178

The information in this article applies to:

Microsoft FoxPro for MS-DOS, versions 1.0, 1.01, and 1.02

The REPLACE command replaces the data that was previously in one field with the data from an expression. Unless a FOR or WHILE clause is specified, only the current record is affected by the REPLACE command.

The REPLACE command does not replace any field or record if any open file is at the end of the file (EOF).

Additional reference words: FoxDos 1.00 1.01 1.x
KBCategory: kbprg
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.