DELETE Command Example Incorrect in Language Reference

 Last reviewed: June 27, 1995
Article ID: Q95238
The information in this article applies to:
  • Microsoft FoxPro for Windows, versions 2.5 and 2.5a
  • Microsoft FoxPro for MS-DOS, versions 2.5 and 2.5a

Page L3-439 of the FoxPro "Language Reference" incorrectly documents a program example for the DELETE command. The first line reads: 

   USE DATABASES
This line should instead read as follows: 

   CLOSE DATABASES
Microsoft has confirmed that this documentation error occurs on Page L3-439 of the FoxPro "Language Reference" manual.

Additional reference words: FoxDos FoxWin 2.50 2.50a DOCERR
KBCategory: kbprg kbdocerr
KBSubcategory: FxprgGeneral

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.