Cycle Command Does Not Work for Desktop Screens

 Last reviewed: June 27, 1995
Article ID: Q97632
The information in this article applies to:
  • Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, and 2.5a
  • Microsoft FoxPro for Windows, versions 2.5 and 2.5a

SUMMARY

The Cycle command on the Window menu is designed to switch between windows defined on the desktop. When a screen set contains several windows and a desktop screen, Cycle stops on the desktop screen. This is normal behavior, since the Cycle command is intended to be used with window screens, not the desktop.

To work around this behavior, define a window with no borders instead of using a desktop screen. This will produce a window that looks like the desktop.

MORE INFORMATION

The Cycle command is used for cycling through window screens in a screen set or windows defined on the desktop. The shortcut key CTRL+F1 can also be used to cycle through windows on the desktop.

Additional reference words: FoxDos FoxWin 2.50 2.00 2.50a
KBCategory: kbprg
KBSubcategory: FxprgGeneral

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.