Output Not Directed to LPT2 with SET PRINTER TO \\SPOOLER

Last reviewed: April 20, 1995
Article ID: Q99761

The information in this article applies to:

Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, and 2.5a

Printed output cannot be directed to the LPT2 port with the command SET PRINTER TO \\SPOOLER command. This command automatically performs a capture of the LPT1 port. The Novell CAPTURE command should be used to direct output to a specific port.

REFERENCES

"Commands & Functions," version 2.0, page C3-792 "Language Reference," version 2.5, page L3-975

Additional reference words: FoxDos 2.00 2.50 2.50a novel
KBCategory: kbprg
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 20, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.