BUG: No Error or Code for Multiple END Statements

 Last reviewed: December 7, 1994
Article ID: Q123661
The information in this article applies to:
  • Microsoft Macro Assembler for MS-DOS, version 6.11
  • Microsoft Macro Assembler for Windows NT, version 6.11

SYMPTOMS

The assembler issues no errors for the following sample code, which contains more than one END statement: 

   .model small
   .code

   RET

   END

   RET

   END
No code is generated for the RET after the first end.

RESOLUTION

Remove any code that appears after the first END statement.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

Additional reference words: 6.11 buglist6.11
KBCategory: kbtool kbbuglist
KBSubcategory: MLIss

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: December 7, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.