PRB: "AT" Combine Types

 Last reviewed: January 9, 1995
Article ID: Q26839
The information in this article applies to:
  • Microsoft Macro Assembler for MS-DOS, versions 5.0, 5.1, and 5.1a
  • Microsoft Macro Assembler for OS/2, versions 5.1 and 5.1a

SYMPTOMS

The Microsoft Macro Assembler will generate a misleading error message when a segment with the AT combine type is specified with a segment value that is too large. The error message generated will be: 

   error A2029: Division by 0 or overflow
It is not clear from the error message that the segment value was too large.

CAUSE

This is the expected behavior of MASM 5.0, 5.1, and 5.1a.

RESOLUTION

MASM 6.0 now generates the following error message: 

   error A2084: constant value too large

MORE INFORMATION

The following sample code can be used to demonstrate the problem.

Sample Code

; Assemble options needed: none 

S1  SEGMENT AT  01234H   ; This segment is OK
S2 ENDS 

S2  SEGMENT AT  12345H   ; This segment generates a misleading error
S2 ENDS

END

Additional reference words: 5.00 5.10 5.10a
KBCategory: kbtool kbprb
KBSubCategory: MLIss

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: January 9, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.