PRB: Cannot Backup Distribution Disks

Last reviewed: January 9, 1995
Article ID: Q28216

The information in this article applies to:

Microsoft Macro Assembler for MS-DOS, versions 5.1 and 5.1a

SYMPTOMS

While trying to make backup copies of the Microsoft Macro Assembler (MASM) 5.1 distribution disks one of the disks will not copy. The disk that will not copy is labeled "Microsoft CodeView and Utilities for MS-OS/2."

CAUSE

The disk should be fine. The information on this disk is required only by individuals who have MS-OS/2 and was intentionally saved on a high-density formatted disk.

RESOLUTION

Since OS/2 must be run on a 286 or 386 machine, reading this disk will not be a problem since these machines typically have high-density floppy drives.

If your machine is less than a 286, you probably have a low-density disk drive and you will not be able to read this disk; however, you will not be running under MS-OS/2 and will not need the information on the disk anyway.

Additional reference words: 5.10 5.10a
KBCategory: kbsetup kbprb
KBSubCategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: January 9, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.