SMTP: Gateway Cannot Run Under Windows NT TCP/IP

Last reviewed: October 20, 1997
Article ID: Q105288
3.00 MS-DOS kb3rdparty

The information in this article applies to:

  • Microsoft Mail Gateway to SMTP, version 3.0

Microsoft Mail Gateway to SMTP version cannot run on Microsoft's TCP/IP for Windows NT, which uses the Winsock API: the SMTP Gateway was not developed to interact with this.

The SMTP Gateway does run on top of two Microsoft TCP/IP products that use the Microsoft LAN Manager APIs:

  • LAN Manager TCP/IP
  • Windows for Workgroups TCP/IP (must use the MS-DOS redirector)

The software must be loaded in the correct order. Start TCP/IP (for LAN Manager or Windows for Workgroups) first with the "load tcpip" command. Then start the TCP/IP application interface, called SOCKET, by typing "SOCKETS". When these have been started, you can start the SMTP Gateway software with the "smtpgate" command.


Additional reference words: 3.00 3.0
KBCategory: kb3rdparty
KBSubcategory: MailGWSMTP


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.