PC WRmt: Entering Addresses Directly on the TO: Line

Last reviewed: November 1, 1995
Article ID: Q105957

The information in this article applies to:

Microsoft Mail Remote for Windows, version 3.2

SUMMARY

With version 3.2 of Microsoft Mail Remote for Windows, if you want to enter addresses directly on the To: line, without first adding them to your Personal Address Book (PAB), you should enclose the address in square brackets.

For example, to send mail to a Microsoft Mail user, type the following:

   [MS:<network>/<postoffice>/<user>]

To send mail to an AT&T user, type

   [AT&T:!<user>]

MORE INFORMATION

Addressing mail to an AT&T Mail user is a unique case, because you must add the exclamation point character (!) in the address.

For more information, query on the following words here in the Microsoft Knowledge Base:

   MailPCWin and mailing and address and list

Additional reference words: 3.20 gateway foreign
KBCategory: kbusage kb3rdparty kbtlc
KBSubCategory: MailPCWRmt

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 1, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.