X400: Err Msg: Mailbox Can Be Mapped Once in an Address

Last reviewed: October 20, 1997
Article ID: Q107101

3.20 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to X.400, version 3.2

SYMPTOMS

The Microsoft Mail Gateway to X.400 administration utility may give the following error when you use the routing section:

   Mailbox can be mapped once in an address conversion.

CAUSE

When you specify an address conversion, you can map each Microsoft Mail attribute (network, postoffice, and mailbox) only once.

RESOLUTION

To cancel an existing Mailbox mapping, select the corresponding X.400 Address Attribute field and choose the Mailbox button. Once the attribute mapping is canceled, you can map it again.

Additional reference words: 3.20 errmsg
KBCategory: kb3rdparty
KBSubcategory: MailGWX400

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.