3COM: How to Control Polling for New Mail

Last reviewed: October 20, 1997
Article ID: Q86945

3.00 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to 3Com 3+Mail, version 3.0

You can set the frequency of polling for the Microsoft Mail Gateway to 3Com 3+Mail by setting the FireInterval parameter in the GATEWAY.INI file. This parameter specifies the elapsed time (in minutes) the gateway waits before it checks for queued mail and starts transferring. The default is 10 minutes.

REFERENCES

"Microsoft Mail Gateway to 3Com 3+Mail Administrator's Guide"

Additional reference words: 3.00 pcmail 3com
KBCategory: kb3rdparty
KBSubcategory: MailGW3Com

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.