X400: Setting the X.400 Log File Debug Option -LD

Last reviewed: October 20, 1997
Article ID: Q87487

3.00 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to X.400, version 3.0

To set the debug option in the Microsoft Mail Gateway to X.400, use the -LD option (case insensitive) at the command line of the gateway program. You should disable message timeout (-rt), because it generates a number of debug messages.

Use the -LD option in conjunction with, not in place of, the -LV logging option.

Additional reference words: 3.00 pcmail
KBCategory: kb3rdparty
KBSubcategory: MailGWX400

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.