X400: Use of "_" Character in the X.400 Version 2.1b3 Setup

Last reviewed: October 20, 1997
Article ID: Q87490

2.10 MS-DOS kb3rdparty

The information in this article applies to:

Microsoft Mail Gateway to X.400, version 3.0

In X.400 version 2.1b3, the underscore character "_" can be used to represent a single space ONLY in the Admin program's Gateway/Setup/MTA Country code, ADMD, and PRMD fields (from the Admin program's Gateway menu, choose Setup, then select one of the above fields) and in the ROUTE.CFG file. To enter a single space in an address, use the typed entry, then simply enter a single space. For example:

   /c=ca/admd= /prmd=cdn/etc.

Single spaces are allowed in the address mapping strings. Enter them just as you enter "typed entry" addresses.

Additional reference words: 2.10 pcmail
KBCategory: kb3rdparty
KBSubcategory: MailGWX400

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 20, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.