DCA X.25 Link Service Problem in SNA Server Setup

Last reviewed: April 17, 1997
Article ID: Q148958

The information in this article applies to:

Microsoft SNA Server for Windows NT, versions 2.0, 2.1, 2.11 and 2.11 Service Pack 1

SYMPTOMS

If you enter incorrect information for "T1 Timeout" or "N2 Retry Limit" in the DCA X.25 Link Service Setup dialog box, you are unable to return to the Setup Message dialog box. No error message appears.

RESOLUTION

To correct this problem, enter the correction information for the entries mentioned above.

STATUS

Microsoft has confirmed this to be a problem in SNA Server versions 2.0, 2.1, 2.11 and 2.11 Service Pack 1. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

Additional query words: prodsna
Keywords : kbnetwork snasetup
Version : 2.00 2.10 2.11 sp1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.