How to Migrate an Existing SNA Server to a New Hardware Platform

Last reviewed: February 4, 1998
Article ID: Q179017
The information in this article applies to:
  • Microsoft SNA Server, versions 2.11, 2.11SP1, 2.11SP2, 3.0, 3.0SP1, 3.0SP2, 4.0

SUMMARY

There may be occasions where it will be necessary to migrate your existing SNA Server configuration to a new computer, or to restore to an existing computer in the event it is rebuilt due to a hardware failure.

MORE INFORMATION

NOTE: It is VERY IMPORTANT to keep a backup copy of your SNA configuration file in a place where it would be unaffected by a harware failure and in a place where it will not be accidentally deleted. Update the configuration EVERY time a modification is made. Without a valid current backup, complete restoration of the existing configuration is impossible.

For more information on backup and restore of the configuration file, please see the following article in the Microsoft Knowledge Base:

   ARTICLE-ID: Q112636
   TITLE: Backup and Restore of COM.CFG

This scenario assumes that the SNA Subdomain consists of only a single SNA server and it is properly configured as the Primary Configuration Server. This procedure would be used in the event of a computer replacement or a complete rebuild of an existing computer following a fatal hardware problem.

  1. Verify that you have a valid backup of your configuration file.
2. Use the Snacfg.exe utility to have a text copy printed to be used in steps 5
   and 7.
3. Remove server from the network physically by shutting the computer off. Then
   remove the server's machine account in the Windows NT Domain using Server 
   manager.
4. Install Windows NT Server along with current Service Pack levels. Add the
   computer to the Windows NT domain with the same machine name as the original.
   Also verify that the same LAN transport protocols are installed. If using 
   TCP/IP, make sure that the proper IP address is assigned.
5. Install SNA Server. Make sure that proper Link Services are installed. These
   would normally be the same Link Services that were installed previously
   unless the server to host physical connection has been changed. For example, 
   a Token Ring card was replaced by Ethernet.
6. Restore the SNA Configuration from backup file. 7. Make sure that connections are configured with the proper Link Service. 8. After verifying proper operation, update SNA Server to the Service Pack level
   that was installed previously, or to the latest Service Pack if a newer one
   is available.
9. Backup configuration file in a place where it would be unaffected by a
   harware failure and in a place where it will not be accidentally deleted.
Keywords          : prodsna snasetup kbfaq
Version           : WINDOWS:2.11,2.11SP1,2.11SP2,3.0,3.0SP1,3.0SP2,4.0
Platform          : WINDOWS
Hardware          : x86
Issue type        : kbhowto kbinfo


================================================================================


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: February 4, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.