An ATTACH May Fail When Using Set_CPIC_Side_Information

Last reviewed: February 11, 1998
Article ID: Q180791
The information in this article applies to:
  • Microsoft SNA Server, versions 3.0, 3.0 SP1, 3.0 SP2

SYMPTOMS

When calling Set_CPIC_Side_Information xcmssi(), the parameter Security_User_Id is 8 bytes long but the APPC layer uses 10 bytes to store the same information. This means it will carry the last two bytes with a value of 0x0000. In the ATTACH (FMH-5) message, trailing spaces (0x40 EBCDIC) will be removed and the actual length of the Security_User_Id value will be set on the Information Field.

If Security_User_Id is less than 8 bytes, it will be padded with spaces and the APPC layer will carry <Security_User_Id> + Space(s) + 0x0000. What this means is that the ATTACH will carry all bytes BEFORE the first space and it will be accepted by the remote end.

If Security_User_Id is equal to 8 bytes, there won't be any padding and the APPC layer will carry <Security_User_Id> + 0x0000. The ATTACH will carry all bytes BEFORE the first Space, in that case <Security_User_Id> + 0x0000. Because this won't match the user id on the remote end, the ATTACH will fail.

When using the SNA Server Manager to configure CPIC Symbolic Destination Names, the User ID and Password parameters are correctly padded with spaces up to 10 bytes before passing them to the APPC layer.

CAUSE

The Set_CPIC_Side_Information (xcmssi) function accepts an 8 byte user ID and password and these needed to be blank padded to 10 bytes before handing to the APPC layer.

STATUS

Microsoft has confirmed this to be a problem in SNA Server versions 3.0, 3.0 SP1, and 3.0 SP2. A supported fix is now available, but has not been fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.

MORE INFORMATION

This problem does not exist in the retail version of SNA Server 4.0.

Keywords          : kbbug3.00 kbbug3.00.sp1 snacpic snaprog kbbug3.00.sp2 kbbuglist
Version           : WINDOWS:3.0,3.0SP1,3.0SP2
Platform          : WINDOWS
Issue type        : kbbug
Solution Type     : kbfix


================================================================================


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: February 11, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.