Windows Reboots at Startup on the Texas Instruments SP1000

Last reviewed: November 22, 1994
Article ID: Q100608

The information in this article applies to:

Microsoft Windows operating system versions 3.1, 3.11

SYMPTOMS

When you start Windows on a Texas Instruments (TI) SP1000, your machine may reboot if the statement DOS=HIGH or DOS=HIGH,UMB is in the CONFIG.SYS file.

RESOLUTION

To work around this problem remove any DOS= commands from your CONFIG.SYS file.

The TI SP1000 may require a machine (/M) switch on the HIMEM.SYS command line in the CONFIG.SYS file. Machine number 8 or 12 should correct this problem. Texas Instruments Technical Support recommends that you try the machine number 12 switch first.

The SP1000 is manufactured by Texas Instruments, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

For more information, call Texas Instruments Technical Support.

KBCategory: kbhw kb3rdparty
KBSubcategory: win31
Additional reference words: 3.10

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 22, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.