Certain Network Adapters Can Use DMA Channels 0-3 Only

Last reviewed: November 21, 1994
Article ID: Q106274
The information in this article applies to:
  • Microsoft Windows for Workgroups version 3.11

SYMPTOMS

When you use Microsoft Windows for Workgroups version 3.11 with a network adapter that uses direct memory access (DMA) in Slave DMA mode, only DMA channels 0, 1, 2, and 3 can be used.

NOTE: An example of a network adapter that uses Slave DMA mode is the Hewlett-Packard 27248A EtherTwist card.

If the card operates in Master DMA mode, it can work on any available DMA channel.

CAUSE

This problem is due to a limitation in the Windows for Workgroups 3.11 Virtual Direct Memory Access driver (VDMAD).

WORKAROUND

The only workaround is to use DMA channel 0, 1, 2, or 3 for your network adapter.

STATUS

Microsoft has confirmed this to be a problem in the Microsoft Windows for Workgroups version 3.11 VDMAD driver. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


KBCategory: kbnetwork kbhw kb3rdparty kbsetup kbbuglist
KBSubcategory: wfw wfwg
Additional reference words: 3.11 hewlett packard HP27248A


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.