Prompted to Do Full Installation in Maintenance-Mode Setup

Last reviewed: November 21, 1994
Article ID: Q117504
The information in this article applies to:
  • Microsoft Windows operating system version 3.11

SYMPTOMS

After you complete a network setup of Windows 3.1 (SETUP /N) and you later try to perform a maintenance-mode setup for Windows 3.1 from your Windows directory, you are prompted to perform a full installation, and you are not allowed to make any changes to the system settings.

CAUSE

Three files must be present in the Windows directory in order to run maintenance-mode setup. These files are WIN.COM, SETUP.EXE, and WINVER.EXE. You experience problems if all three files are not present. When you perform a network installation of Windows using the SETUP/N command, the setup routine places a minimal number of Windows files in the local Windows directory. SETUP.EXE, by default, is not installed in the local Windows directory.

RESOLUTION

To correct this problem, copy SETUP.EXE to the local Windows directory from Disk 1 of the Windows distribution disk set or from the shared Windows directory.


KBCategory: kbnetwork kbsetup
KBSubcategory: win31
Additional reference words: 3.10 3.1


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.