CorelDRAW! Gives WALDO Error Using Extrude or Blend

 Last reviewed: November 23, 1994
Article ID: Q83379
The information in this article applies to:
  • Microsoft Windows operating system versions 3.1, 3.11

SUMMARY

When you try to perform the extrude or blend functions in CorelDRAW! version 2.0 with Windows version 3.1, a problem occurs in CorelDRAW!'s WALDO program module. The following error message displays: 

   WALDO has created a fault at . . .
You cannot perform the extrude or blend functions, but you have a choice of proceeding anyway or exiting the program. This problem occurs only in CorelDRAW! version 2.0 and was corrected in version 2.001.

MORE INFORMATION

Corel Corporation has confirmed this to be a problem with CorelDRAW! 2.0 running under Windows 3.1 and provides an upgrade option to registered users of CorelDRAW!.

For more information on this upgrade, contact Corel Technical Support.

CorelDRAW! is manufactured by Corel Corporation, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

KBCategory: kbtool kb3rdparty
KBSubcategory: win31
Additional reference words: 3.10 3.11 3.1 Corel Draw

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.