SMC_ARC.DOS May Result in a POR Failure or Adapter Not Found

Last reviewed: November 21, 1994
Article ID: Q94363
The information in this article applies to:
  • Microsoft Windows for Workgroups versions 3.1, 3.11

SYMPTOMS

The following error message may occur during startup if the SMC_ARC.DOS driver is being used:

   SMC Arcnet Mac Driver 10/01/91 Version 2.05 PS110,PS210 Board in a PS/2
   System

   \dev\smc_arc Error:POR failure or Adapter not found

This error indicates that the system board is being detected as a PS/2 board even though it is an ISA or EISA board.

WORKAROUND

To work around the problem, edit the MAC driver section (example: [MS$SMC270])of the Windows for Workgroups PROTOCOL.INI file adding the following line:

   Micro_Channel=0

Here is an example of how the section reads:

[MS$SMC270] DriverName=SMC_ARC$ interrupt=2 iobase=0x2E0 memorybase=0xD000 MICRO_CHANNEL=0

WARNING: When editing the PROTOCOL.INI file manually, always remember that modifications made with the Network settings in Control Panel may result in the loss of any manual editing. Therefore, it may be necessary to add this entry again after modifying settings through Control Panel.


KBCategory: kbnetwork kberrmsg kbhw kbprb
KBSubcategory: wfw wfwg winboot
Additional reference words: 3.1 3.10 ps2 micro channel err msg boot process
bootup start up


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.