Cannot Change Network Printer Location from a Command Prompt

Last reviewed: January 16, 1998
Article ID: Q176918
The information in this article applies to:
  • Microsoft Windows 95

SYMPTOMS

When you try to change the network path for a printer (LPT) port by using the NET USE command at a command prompt, the path changes for MS-DOS-based programs, but not for Windows-based programs.

RESOLUTION

To work around this issue, change the network path in Control Panel instead of using the NET USE command. To do so, follow these steps:

  1. Click Start, point to Settings, and then click Printers.

  2. Right-click the printer whose network path you want to change, and then click Properties.

  3. Click the Details tab, click End Capture, and then click the LPT port you want to release.

  4. Click Capture Port, and then click the LPT port you want to capture in the Device box.

  5. In the Path box, type the path to your network printer.

  6. Click OK, click OK, and then close the Printers window.

STATUS

This behavior is by design.


Additional query words: 95
Keywords : win95 kbnetwork kbprint
Version : WINDOWS:95
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: January 16, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.