Program Priority and Multithreaded Applications

 Last reviewed: March 25, 1997
Article ID: Q106253
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1
  • Microsoft Windows NT Server version 4.0
  • Microsoft Windows NT Workstation version 4.0

SUMMARY

When a program is started under Windows NT, it will have a priority class that is either normal or equal to the priority class specified in the command line when using the START command (Idle, Normal, High, or Realtime). The priority class determines at which priority (from 1 to 31) the program will run. In a multithreaded application, threads spawned by the program can be lower or higher than the current priority class of the program; however, all thread priorities will be relative to the priority class of the parent program. While a program can change its priority class after starting, all of its threads will still have the same relative priority.

MORE INFORMATION

When a process spawns a thread, one of the parameters in the function call sets the thread priority relative to the priority of the parent process. This parameter can have one of the following values: Idle, Lowest, Below Normal, Normal, Above Normal, Highest and Time Critical. The starting priority set for the thread will be based upon that parameter and the current priority of the process starting the thread. The priorities are as follows: 

RELATIVE                  PROCESS PRIORITY CLASS
THREAD                Normal, in      Normal, in
PRIORITY       Idle   Background      Foreground    High    Realtime

Time Critical   15        15              15         15        31
Highest          6         9              11         15        26
Above Normal     5         8              10         14        25
Normal           4         7               9         13        24
Below Normal     3         6               8         12        23
Lowest           2         5               7         11        22
Idle             1         1               1          1        16
The table above lists the base priority of a thread, which is set by calling the function SetThreadPriority; however, a thread’s priority can change as the thread executes. The system can boost a thread’s priority higher as time goes on and then reduce the priority back down to the base, though Windows NT will never reduce a thread lower than its base priority. The system will boost a thread’s priority when a user interacts directly with a thread, including mouse and keyboard input or simply bringing the thread to the foreground.

For more information on process priorities, query on the following key words in the WINNT Knowledge Base: 

   priority and process

Additional query words: prodnt
Keywords : kbenv ntconfig NTSrvWkst
Version : 3.1 4.0
Platform : WinNT

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 25, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.