Err Msg: Error 720: No PPP Control Protocols Configured

Last reviewed: November 19, 1997
Article ID: Q122748

The information in this article applies to:

Microsoft Windows NT Workstation versions 3.5, 3.51, and 4.0
Microsoft Windows NT Server versions 3.5, 3.51, and 4.0

SYMPTOMS

When you attempt to connect to a Remote Access Service (RAS) Server using the TCP/IP protocol, you may receive the following error message:

   Error 720: No PPP control protocols configured.

CAUSE

The RAS Server to which you are dialing does not have the TCP/IP protocol installed or configured for RAS.

RESOLUTION

To resolve this issue you will need to edit your phone book entry to use whatever protocol the RAS Server is using.

Additional query words: point-to-point prodnt
Keywords : NTRAS NTSrvWkst nttcp kbnetwork
Version : 3.5 4.0
Platform : winnt
Issue type : kberrmsg

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 19, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.