Maximum Number of Send and Receive Packets Used By NBF

Last reviewed: March 25, 1997
Article ID: Q129842

The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1
  • Microsoft Windows NT Workstation version 3.5
  • Microsoft Windows NT Server version 3.5
  • Microsoft Windows NT Server version 4.0
  • Microsoft Windows NT Workstation version 4.0

SUMMARY

The NBF (NetBEUI) transport uses SendPacketPoolSize and ReceivePacketPoolSize parameters to limit the maximum number of send and receive packets it dynamically allocates. If send and receive packet exhausted errors occur frequently, you may need to increment the values of these parameters.

MORE INFORMATION

Receive packets are used by NBF to handle the incoming frames. Send packets are used for connection oriented data. SendPacketPoolSize and ReceivePacketPoolSize control the maximum number of send and receive packets NBF can allocate at one time. The default value of SendPacketPoolSize is 100 and the default value of ReceivePacketPoolSize is 30.

Under normal load, these parameters do not need to be changed. In some cases, these parameters need to be adjusted. For example, too many reads and writes are carried out by client workstations, and you need to optimize network throughput. You may also want to change these parameters if a workstation cannot connect to a server when the network is under heavy load.

To see if the values of these two parameters need to be modified:

  1. Run Performance Monitor.

  2. Choose NetBEUI Resource.

    The followig three counters are available in the Counter list box:

          Times Exhausted
          Used Average
          Used Maximum
    

    The Instance list box shows counters for each net board installed.

  3. To see the number of times ReceivePackets exhausted, select Times exhausted in the Counter list box and \Device\NbfAdopter ==>Receive Packet (23).

To add or modify the SendPacketPoolSize or ReceivePacketPoolSize parameters:

The following details steps to take to add /modify the WARNING: Using Registry Editor incorrectly can cause serious, system-wide problems that may require you to reinstall Windows NT to correct them. Microsoft cannot guarantee that any problems resulting from the use of Registry Editor can be solved. Use this tool at your own risk.

  1. Run Registry Editor (REGEDT32.EXE).

  2. From the HKEY_LOCAL_MACHINE subtree, go to the following key:

          \Services\NBF\Parameters
    

  3. If the SendPacketPoolSize or ReceivePacketPoolSize key exists, choose Edit Value from the Edit menu and change the value as needed.

  4. If the SendPacketPoolSize or ReceivePacketPoolSize key does not exist, choose Add Key from the Edit menu and add the following information:

          Value Name: SendPacketPoolSize
          Data Type:  REG_DWORD
    
          Value:      Insert the desired value
    


Additional query words: prodnt
Keywords : kbnetwork ntprotocol NTSrvWkst
Version : 3.1 3.5 4.0
Platform : WinNT


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 25, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.