Using FTP Batch Scripts

Last reviewed: April 10, 1997
Article ID: Q96269
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1

FTP (file transfer protocol) is a file transfer utility commonly used with UNIX systems.

FTP is capable of using scripts (lists of commands from external files). The following example demonstrates a script that opens a connection to IP address 11.11.11.11, logs onto the host as a guest with the password guest, uploads the FILE1 file, and quits:

   open 11.11.11.11
   guest
   guest
   put file1
   quit

You must use the -S option for FTP to read this file under Windows NT. If the previous script was in a file called TEST.SCR, you could start the script by typing the following:

   ftp -s:test.scr


Additional query words: prodnt
Keywords : kbinterop ntinterop
Version : 3.1
Platform : WinNT


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 10, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.