ENTRYID

The ENTRYID structure contains an entry identifier for a MAPI object.

Quick Info

Header file: MAPIDEFS.H
Related macros: CbNewENTRYID
SizedENTRYID

typedef struct 
{ 
     BYTE        abFlags[4]; 
     BYTE        ab[MAPI_DIM]; 
} ENTRYID, FAR *LPENTRYID; 
 

Members

abFlags
Bitmask of flags that provide information describing the object. Only the first byte of the flags, abFlags[0], may be set by the provider; the other three are reserved. These flags must not be set for permanent entry identifiers; they are only set for short-term entry identifiers. To clients, this structure is read-only.

The following flags can be set in abFlags[0]:

MAPI_NOTRECIP
The entry identifier cannot be used as a recipient on a message.
MAPI_NOTRESERVED
Other users cannot access the entry identifier.
MAPI_NOW
The entry identifier cannot be used at other times.
MAPI_SHORTTERM
The entry identifier is short-term. All other values in this byte must be set unless other uses of the entry identifier are allowed.
MAPI_THISSESSION
The entry identifier cannot be used on other sessions.
ab
Indicates an array of binary data used by service providers. The client application cannot use this array.

Remarks

The ENTRYID structure is used by message store and address book providers to construct unique identifiers for their objects. Entry identifiers are used to identify the following types of objects:

Message stores

Folders

Messages

Address book containers

Distribution lists

Messaging users

Status objects

Profile sections

Each provider uses a format for the ENTRYID structure that makes sense for that provider.

Entry identifiers cannot be compared directly because one object can be represented by two different binary values. To determine if two entry identifiers represent the same object, call the IMAPISession::CompareEntryIDs method.

When a client calls an object's IMAPIProp::GetProps method to retrieve its entry identifier, the object returns the most permanent form of the entry identifier. A client can verify that an entry identifier is long-term by checking that none of the flags are set in the first byte of the abFlags member.

When a client accesses an entry identifier through a column in a table, most likely this entry identifier is short-term rather than long-term. Short-term entry identifiers can be used to open their corresponding objects only in the current MAPI session. A client can verify that an entry identifier is short-term by checking that all of the flags are set in the first byte of the abFlags member.

Some entry identifiers are short-term, but have long-term use. Such an entry identifier will have one or more of the appropriate flags set in the first byte of its abFlags member.

An ENTRYID structure is similar to a FLATENTRY structure. However, there are some differences:

Clients should always pass in naturally aligned entry identifiers. Although providers should handle arbitrarily aligned entry identifiers, clients should not expect this behavior. Failure to pass a suitable aligned entry identifier to a method can result in an alignment fault on RISC processors.

The natural alignment factor, typically 8 bytes, is the largest data type supported by the CPU, and usually the same alignment factor used by the system memory allocator. A naturally aligned memory address allows the CPU to access any data type it supports at that address without generating an alignment fault. For RISC CPUs, a data type of size N bytes must usually be aligned on an even multiple of N bytes, with the address being an even multiple of N.

For more information, see Entry Identifiers.

See Also

ID Structures, IMAPISupport::CompareEntryIDs, PR_RECORD_KEY