MiniportSetInformation

NDIS_STATUS
    MiniportSetInformation(
        IN NDIS_HANDLE
 MiniportAdapterContext,
        IN NDIS_OID Oid,
        IN PVOID InformationBuffer,
        IN ULONG InformationBufferLength,
        OUT PULONG BytesRead,
        OUT PULONG BytesNeeded
        );

MiniportSetInformation is a required function that allows bound protocol drivers (or NDIS) to request changes in the state information that the miniport maintains for particular OIDs, such as changes in multicast addresses.

Parameters

MiniportAdapterContext
Specifies the handle to a miniport-allocated context area in which the driver maintains per-NIC state, set up by MiniportInitialize.
Oid
Specifies the system-defined OID_XXX code designating the set operation the driver should carry out.
InformationBuffer
Points to a buffer containing the OID-specific data used by MiniportSetInformation for the set.
InformationBufferLength
Specifies the number of bytes at InformationBuffer.
BytesRead
Points to a variable that MiniportSetInformation sets to the number of bytes it read from the buffer at InformationBuffer.
BytesNeeded
Points to a variable that MiniportSetInformation sets to the number of additional bytes it needs to satisfy the request if InformationBufferLength is less than Oid requires.

Return Value

MiniportSetInformation can return one of the following:

NDIS_STATUS_SUCCESS
MiniportSetInformation used the data at InformationBuffer to set itself or its NIC to the state required by the given Oid, and it set the variable at BytesRead to the amount of supplied data it used.
NDIS_STATUS_PENDING
The driver will complete the request asynchronously with a call to NdisMSetInformationComplete when it has set itself or its NIC to the state requested.
NDIS_STATUS_INVALID_OID
MiniportSetInformation did not recognize the Oid.
NDIS_STATUS_INVALID_LENGTH
The InformationBufferLength does not match the length required by the given Oid. MiniportSetInformation returned how many bytes the buffer should be at BytesNeeded.
NDIS_STATUS_INVALID_DATA
The data supplied at InformationBuffer was invalid for the given Oid.
NDIS_STATUS_NOT_ACCEPTED
MiniportSetInformation attempted the requested set operation on the NIC but was unsuccessful.
NDIS_STATUS_NOT_SUPPORTED
MiniportSetInformation does not support the Oid, which is optional.
NDIS_STATUS_RESOURCES
MiniportSetInformation could not carry out the requested operation due to resource constraints. This return value does not necessarily mean that the same request, submitted at a later time, will be failed for the same reason.

Comments

NDIS calls MiniportSetInformation either on its own behalf, such as to manage bindings to the miniport, or when a bound protocol driver calls NdisRequest.

If MiniportSetInformation returns NDIS_STATUS_PENDING, the driver must complete the request later by calling NdisMSetInformationComplete. Until it completes any request, the miniport can safely access the memory at InformationBuffer, BytesRead, and BytesNeeded. After the miniport completes any set request, ownership of these variables and the buffer reverts to NDIS or the caller of NdisRequest, whichever allocated the memory.

After a call to MiniportSetInformation, NDIS submits no other requests to the driver until it has completed the operation, either synchronously or asynchronously. Instead, NDIS holds requests queued until the current set operation is completed.

For more information about the system-defined OIDs, see Chapter 5.

MiniportSetInformation can be pre-empted by an interrupt.

By default, MiniportSetInformation runs at IRQL DISPATCH_LEVEL.

See Also

MiniportInitialize, MiniportQueryInformation, NdisMSetInformationComplete, NdisRequest, NDIS_REQUEST