SetWaitableTimer [New

SetWaitableTimer

[New - Windows NT]

The SetWaitableTimer function activates the specified "waitable" timer. When the due time arrives, the timer is signaled and the thread that set the timer calls the optional completion routine.

BOOL SetWaitableTimer(

HANDLE hTimer,	// handle to a timer object
const LARGE_INTEGER *pDueTime,	// when timer will become signaled
LONG lPeriod,	// periodic timer interval
PTIMERAPCROUTINE pfnCompletionRoutine,	// pointer to the completion routine
LPVOID lpArgToCompletionRoutine,	// data passed to the completion routine
BOOL fResume	// flag for resume state
);

Parameters

hTimer

Identifies the timer object. The CreateWaitableTimer or OpenWaitableTimer function returns this handle.

pDueTime

Specifies when the state of the timer is to be set to signaled, in 100 nanosecond intervals. Use the format described by the FILETIME structure. Positive values indicate absolute time. Negative values indicate relative time. The actual timer accuracy depends on the capability of your hardware.

lPeriod

Specifies the period of the timer, in milliseconds. If lPeriod is zero, the timer is signaled once. If lPeriod is greater than zero, the timer is periodic. A periodic timer automatically reactivates each time the period elapses, until the timer is canceled using the CancelWaitableTimer function or reset using SetWaitableTimer. If lPeriod is less than zero, the function fails.

pfnCompletionRoutine

Specifies an optional completion routine. The completion routine has the following prototype:

VOID

(APIENTRY *PTIMERAPCROUTINE)(

LPVOID lpArgToCompletionRoutine,

DWORD dwTimerLowValue,

DWORD dwTimerHighValue

);

The argument for the completion routine is specified when the timer is made active, in the lpArgToCompletionRoutine parameter. The completion routine also takes two DWORD values that specify the high and low time values of the time at which the timer was signaled. These values are passed to the routine by the system using the FILETIME format..

lpArgToCompletionRoutine

Pointer to the structure that is passed to the function specified by the pointer pfnCompletionRoutine.

fResume

Specifies whether to restore a system in suspended power conservation mode when the timer state is set to signaled. If fResume is TRUE on a platform that does not support a restore, the call will succeed, but GetLastError returns ERROR_NOT_SUPPORTED.

Return Value

If the function succeeds, the return value is nonzero.

If the function fails, the return value is zero. To get extended error information, call GetLastError.

Remarks

Timer are initially inactive. Timers are activated by calling SetWaitableTimer. If the timer is already active when you call SetWaitableTimer, the timer is stopped, then it is reactivated. Stopping the timer in this manner does not set the timer state to signaled, so threads blocked in a wait operation on the timer remain blocked.

When the specified due time arrives, the timer becomes inactive. The state of the timer is set to signaled, the timer is reactivated using the specified period, and the thread calls the completion routine. If you call SetWaitableTimer and the thread is not in an alertable state, the completion routine is canceled.

When a manual-reset timer is set to the signaled state, it remains in this state until SetWaitableTimer is called to reset the timer. As a result, a periodic manual-reset timer is set to the signaled state when the initial due time arrives and remains signaled until it is canceled or reset. When a synchronization timer is set to the signaled state, it remains in this state until a thread completes a wait operation on the timer object.